Quick specs
- Capacity10 oz (295 ml)
- H₂ OutputUp to 5,000 PPB
- Battery~15 cycles / charge
- Charge time4–5 hrs (USB-C)
- Cycle modes3 min · 10 min
- BodyTritan™ + Anodized AL
What hydrogen water actually does
- Reduces inflammation markers
- Acts as a selective antioxidant — neutralizes only harmful free radicals
- Aids muscle recovery between workouts
- Improves hydration at the cellular level
- Supports steady energy and focus
Recommended drinking schedule
For best results, drink 3–5 ATOM bottles per day. Start with one on an empty stomach within 15 minutes of waking, another 30 minutes before lunch, and continue throughout the afternoon and evening.
Most people feel a difference within 7–14 days of consistent daily use.
Full setup (first use)
- Unscrew the bottle from the stainless steel base.
- Remove the small wet plug from the center of the PEM membrane — this keeps the membrane hydrated in shipping.
- Hand-wash the bottle and lid with warm water and mild dish soap. Rinse thoroughly. Do NOT submerge the base.
- Reassemble and charge the base fully using the included USB-C cable. A solid green LED means it's ready.
- Fill with filtered, spring, or mineral water — avoid heavily chlorinated tap water and sparkling water.
How to use it daily
Press once for the 3-minute cycle. Double-press for the 10-minute high-concentration cycle.
The LED ring will pulse during the cycle and turn off when complete. You'll see small hydrogen bubbles rising from the base plate — that's the SPE/PEM membrane working correctly.
Drink within 15–20 minutes for peak hydrogen concentration.
Cleaning & descaling
Every 2–3 days: Hand-wash bottle and lid with warm soapy water. Wipe the base with a damp cloth only.
Monthly: Descale the PEM membrane. Fill the bottle with a 50/50 mix of distilled water and food-grade citric acid (or white vinegar). Run one 10-minute cycle. Rinse and run two cycles of plain filtered water before drinking again.
Keep the small vent on the bottom of the base clear of debris.
Troubleshooting
- Weak or no bubbling: Most often a membrane that needs descaling. Run the descaling cycle above. If that doesn't help, contact support.
- Bottle won't power on: Charge for a full 4–5 hours. If LED still doesn't light, try another USB-C cable / wall adapter before reaching out.
- Leak between bottle and base: Inspect the silicone seal on top of the base for debris or wear. Wipe clean, reseat, and hand-tighten — never with tools.
- Off taste: Run a descaling cycle and rinse thoroughly. Always use clean filtered, spring, or mineral water.
FAQs
- How often should I charge? Every ~15 cycles, or when the LED pulses red.
- Can I use hot water? No. Keep water under 120°F (50°C). Hot water damages the PEM membrane and voids the warranty.
- Can I drink the water right after a cycle? Yes — best within 15–20 minutes for peak hydrogen.
- Is the bottle dishwasher safe? No. Always hand-wash. The base must never go in the dishwasher.
- Warranty? 1-year manufacturer warranty on the electronics. Add Lifetime Protection for extended coverage.
