All our hydrogen producing water products use a Proton Exchange Membrane (PEM) paired with a Solid Polymer Electrolyte (SPE) electrolysis to split H2O and produce pure molecular hydrogen at high concentrations.

Yes, our products use glass.

We are in the process of designing a product that uses Tritan plastic. Very strong non-toxic plastic that will last for years.

Certainly, you may transfer your freshly hydrogenated water into an alternative glass or stainless steel vessel. It's worth noting, however, that even if the container is sealed, the concentration of hydrogen gas will persist for about 10 to 15 minutes.

When you first receive your bottle, there will be a cap covering the PEM plates in the center of the bottle. This cap contains a small amount of water (100% normal) this water keeps the membrane hydrated while we store them in our warehouses. Just remove the cap and wash out the bottle before use.

Note that the water may escape into the bottle causing the inside to look wet and potentially like it's used. Rest assured that your bottle is NOT USED and some water is completely normal.

All remaining oxygen gas is vented from the bottle so only pure molecular hydrogen becomes infused in your water.

Clean with a light non-abrasive soap and warm water. If you use hard water with high mineral content, you may need to descale your unit once in a while. To do this, pour 1/4 cup of distilled white vinegar onto the titanium plates (located in the center of the base) so that the plate's are fully submerged. Let the white vinegar sit for 60-90 minutes, then rinse with water. Do this once or twice per month for optimal results.

Do not submerge the base underwater. Do not run the base through the dishwasher or clean the base with a wire or metal brush.

Thanks to our patent pending proton exchange membrane, you can use regular tap water, filtered water, reverse osmosis, and purified water in your bottle or pitcher.

If you received your bottle or pitcher and it does not produce hydrogen bubbles, or it stopped. Fill your bottle or pitcher with warm water and allow the PEM unit located at the base to soak in water for 24 hours. This will prime the proton exchange membrane which may have dried out stopping it from working properly.

We recommend using room temp, cold water or iced water. DO NOT pour boiling hot water in your bottle or pitcher, as it may cause damage to the proton exchange membrane (PEM).

Doing so may void the warranty.

Depending on which bottle you have, it will be able to generate 15 to 20 times under one full charge and it takes approximately 5-7 hours to fully charge. Remember to always use the supplied USB charging cable.

1.6 ppm hydrogen will remain for up to 15 minutes or longer when the water was kept in a sealed container. Also whenever you're ready to drink more hydrogen ionized water, all you have to do is just press the power button and the bottle will run for 3 minutes.

Nope! That is one of the main benefits to an IonBottle compared to our single use competitors out there. Our bottles are reusable, rechargable, and never stop creating Hydrogen water for years to come.

According to the research conducted, the patients & athletes that consumed 4-5 bottles per day or about 60 ounces of hydrogen-rich water would achieve optimal results and benefits.

The responses we have received from our customers is that their water has a better taste after being run through their ionizing water bottle or pitcher then before.

Original bottle - PDF manual
Pro bottle - PDF manual
Pitcher - PDF manual